Used – 2020 Peterbilt 365 3-axle Diesel Truck Tractor: (was new in August 2020)… 66,000 lb GVWR, Truck Cab White, 12L Cummins – 450 hp – 1,650 ft/lb torque, Eaton Ultrashift Plus automated 13 spd trans., approx. 79,000 miles, 4,400 engine hours and 950 PTO hours, 204” wheel base, 20,000 lb fronts with 425/65R22.5 Front Floatation tires on Alum rims, 46,000 LB Rears on Air-Ride Suspension, double frame chassis, Truck Loaded with Options Including: Engine Brake, Air Cond., AM/FM stereo, Bluetooth, cruise, tilt/tele steer column, power windows & locks, chrome bumper/grill, heated mirrors, eng block heater, painted ext visor, trailer tow package, rear wheel lock ups, 100 gal alum fuel tank, etc…

PM 47529 Knuckle Boom Folding Hydraulic 9 ext Knuckle Boom – 87’ vertical vertical reach with SG-280 Grapple Saw
Horizontal Capacity: 19,580 lb @ 13’, 10,000 lb @ 24’, 5,600 lb @ 37’, 3,600 lb @ 52’, 2,700 lb @ 66’, 2,400 lb @ 74’

– PM Power-Link connections at Main, Knuckle & Jib Cylinders, High Torque Rack and gear 410 degree non continuous rotation
– Double pilot operated on slewing and pilot operated check valves on all cylinders
– Extra Wide Main outriggers at pedestal, double beam – hyd out & down 26’ 3” span,
– Rear Aux stabilizers – hyd out & down 16’ span, Single Front Bumper Stabilizer to allow full capacity over the front
– Hydraulic Oil Cooler, high pressure return filter and min. 100 –gallon hyd aluminum oil tank with gate valves mounted at front under deck
– Lift a 10’ cage up close at 2’ in front of boom with special LC type extra retraction feature of the extensions
– Double speed extensions – 2nd active valving for two boom extensions to extend and (or) retract at the same to allow for quick efficiency
– Simplified Hydraulics – Hydraulic overload LLD protection and load holding valve – Offers Simplicity, Reliability & low maintenance
– DANFOSS Proportional Control Valve at Top-Seat with Ladder Access – & SCANRECO Proportional Radio Remote Control
– Radio Remote Control includes: 2-batteries, in-cab charger, and back-up cord – 5 level turtle (micro) slow down mode

Also Included Are:
– Engine start/stop and variable engine RPM control from remote, – (5 pcs) 2” PVC Stabilizer Pads with holders installed,
– 36” Aluminum Tool Box installed, – New SG-280 Grapple Saw

In Stock and Ready to Go – Clean unit – $ 325,000 USD

Call 917-525-7233 or 347-925-0523