HOLIDAY SHIPPING
No orders will ship on Nov 28 | Nov 29 order cutoff time is 2pm Eastern Time
No orders will ship on Nov 28 | Nov 29 order cutoff time is 2pm Eastern Time
–
1. Remove the drive belt cover. (17mm hex)
2. Loosen the two bolts for the saw motor. (10mm allen)
3. Tension the belt by tightening the saw motor diagonally upwards with a suitable tool (marked in blue in picture)
4. Tighten the saw motor in the direction of the green arrow.
5. Check the tension is correct. The belt should be possible to move about 1/4″ in both directions. It should by quite firm when trying to move it.
